Message from customer:
Whenever I run the product, I can't see my network. Interestingly, if I
uninstall and re-install the product, I can see my network. If I restart
my computer, I can't.
If I load the program after my computer boots up
(manually), I can see my network.
The product is doing its job: the problem is that if you
can see your Network Neighborhood, then everyone else on
the Internet can see you. The product is designed to stop
that. (Remember, the Internet is TWO WAY communication).
If you just want things to work, you can go into
the product and enable either Trusting
or enable "Allow Internet file sharing".
This is bad, because you will probably accidentally share
your entire hard drive with the rest of the Internet.
A better alternative is to reconfigure your system
to run File and Print Sharing on top of NetBEUI rather
than TCP/IP: TCP/IP transfers your data across the entire
Internet, NetBEUI only transfers data within your home.
